White wall mount bracket for elastic cord

A white wall mount bracket that disappears into the wall

The white wall mount bracket for elastic cord ends a barrier line against a wall without leaving a dark mark. Finished in RAL 9003, it merges with the paint of a gallery, showroom or white cube. You see the cord reach the wall, not the anchor point.

A closed line with no foot on the floor

A row of posts that breaks off leaves a gap at the side. By attaching the cord to the wall, you close the line and avoid adding a foot on the floor, which keeps circulation and cleaning clear. This matters most in rooms where children may try to slip past along the edge.

Fitting and compatibility

Screw and wall plug

The bracket is fitted with a screw and a wall plug, at the height of the post tops, so that the cord stays properly level. Check the type of wall before choosing the plug: plasterboard, brick and concrete do not call for the same one.

For Ø 6 mm cord

It takes the end of a 6 mm elastic cord, such as the white polyethylene cord, matched to the shade of the bracket. The polypropylene sheath colours also work, for a more visible line.

With which posts

It goes equally well with the white 90 cm guide post and the white 45 cm low guide post, so that everything stays the same shade. If the wall is dark, the black wall mount bracket is the better choice.

Why choose white for the end of the line

A detail that counts in a pared-back room

In a carefully crafted scenography, it is often the smallest accessory that gives the whole thing away. A dark support on a white wall draws the eye to the exact spot where the cord stops. In white, the join disappears and the line seems to grow out of the wall itself.

A lasting fitting

Once fixed, the piece stays in place for the whole length of an exhibition, or longer if the layout is permanent. If the hang changes, the cord is released at the end and recut to the new length.